7.4V Li-ion Replacement Battery, Part # 902654 | Paslode
Specifications:
Battery Cell: High-grade, durable
Battery Type: Li-ion
Battery Voltage: 7.4V
Battery Capacity: 1500mAh / 1.5Ah / 11Wh
- For use in all Paslode Lithium-ion (Li-ion) fuel powered cordless nailers
- 16 Ga Angled Cordless Li-ion Finish Nailer, Model IM250A li, Part # 902400;
- Cordless Li-ion Framing Nailer, Model CF325XP, Part # 905600;
- 16 Ga Straight Cordless Li-ion Finish Nailer, Model IM250S-Li, Part # 916000;
- 18 Ga. Cordless Li-ion Brad Nailer, Model IM200Li, Part # 918000;
- Cordless Framing Nailer, Model CF325Li, Part # 902600;
- Impulse Framing Nailer, Product Code B20543; (B20543A)
- Drives up to 9,000 nails per charge in Framing Nailers and 12,000 nails per charge in Trim Nailers
- 2 minute quick charge will drive up to 200 nails
- Charges in 1.5 hours
- Part # 902654
Charging Instructions:
1, Remove the wall transformer from the tool case and plug into a 120V AC outlet. Set the charger base on a stable surface and insert the wall transformer unit’s plus into the plug receptacle on the base of the charger (see diagram). A green light indicates power is on and charging system is ready.
2, Remove the battery from tool or case and insert terminals down into charger. The red light will come on indicating that the battery is charging, the green light will go out.
[NOTE: If battery is completely discharged the red light and the green light may flash back and forth for up to 20 minutes. This safety feature slowly recharges the battery until it is ready to accept the full charging current. If the red and green lights continue to flash after 20 minutes, the battery may be damaged, replace the battery.]
3, After charging, the red light will go out and the green light will come on, indicating that the battery is fully charged. The charger will keep the battery at full charge until it is removed.
4, Unplug the wall transformer unit from the charger and remove the wall transformer unit from the 120V AC outlet.
Do Not:
1, Charge battery outdoors or in temperatures below 5℃ (40°F).
2, Allow metal objects to come into contact with battery terminals.
3, Puncture or attempt to open battery case or cells.
4, Store battery where it will be subjected to temperatures about 49℃ (120°F).
5, Incinerate battery.
6, Use a defective battery charger, one that overheats and / or smokes when plugged in.
7, Immerse the battery in water.
Important Charging Notes:
The first step in preparing a new tool for operation is to fully charge the battery. New batteries are shipped partially discharged and must be charged prior to use. Batteries will take 5 minutes to 1 hour to recharge (time will be dependent on the amount of battery discharge).
Battery disposal:
This Paslode replacement batteries contain lithium and should be recycled or disposed of responsibly.
Contact your local recycling center for information on where to correctly dispose of Li-ion batteries.
Battery Standby
The battery can be placed in the standby position if the tool is not going to be used for a period of time.
Place the battery into the standby (‘OFF’) position by pushing down on the locking tab and sliding the battery back, until the locking tab clicks into the standby position.
Professional Battery Blog 